Electrical test & measurement

HIOKI ST4030A Impulse Winding Tester

The HIOKI ST4030A impulse winding tester (surge tester) diagnoses the insulation quality of motor windings, including rotors and stators in their assembled state.

Brand
HIOKI
Reference
ST4030A
Datasheet
PDF by email
Supply
Morocco & Africa

Description

The HIOKI ST4030A impulse winding tester (surge tester) diagnoses the insulation quality of motor windings, including rotors and stators in their assembled state. Instead of comparing waveform areas, it quantifies the response waveform as LC and RC values, which reveals single-turn faults that conventional testers miss. With 200 MHz sampling at 12-bit resolution, up to 4200 V applied voltage and an optional partial discharge detection function, it serves motor production lines and rewinding workshops.

At a glance

Test method
Impulse (surge) test with response waveform quantification (LC and RC values)
Waveform detection
200 MHz high-speed sampling, 12-bit resolution
Applied voltage
Up to 4200 V

Additional technical specifications

Use these listed characteristics as a starting point. Confirm the final specification for your chosen configuration.

Fault detection
Identifies single-turn faults; partial discharge detection between windings (option)
Key applications
Motor winding insulation quality and deterioration diagnosis, coil and stator production testing
Back to product enquiry
HIOKI ST4030A Impulse Winding Tester – Impulse winding testers
Component & Battery Testing · Impulse winding testers

Compare other instruments in our catalog before defining your requirements.

Explore this category
HIOKI IM7580 Series High-Frequency Impedance Analyzer

Electrical test & measurement

HIOKI IM7580 Series High-Frequency Impedance Analyzer

The HIOKI IM7580 series are high-frequency impedance analyzers for inspecting RF inductors, capacitors and EMC components on production lines and in the laboratory. Five models cover measurement frequencies from 100 kHz up to 3 GHz, each working in both impedance analyzer and LCR meter modes. A 0.5 ms analog measurement time, 0.07% typical repeatability, a contact check and five equivalent-circuit analysis models support fast, reliable sorting of common-mode filters, ferrite bead arrays and power inductors.

View product
HIOKI IM3590 Chemical Impedance Analyzer

Electrical test & measurement

HIOKI IM3590 Chemical Impedance Analyzer

The HIOKI IM3590 is a chemical impedance analyzer for electrochemical impedance spectroscopy of batteries, electrochemical components and materials. It sweeps from 1 mHz to 200 kHz with ±0.05% basic accuracy and uses an automatically adjusted DC bias to measure the internal impedance of battery cells. Cole-Cole plots and equivalent-circuit analysis are built in and shown on the 5.7-inch touch display, giving battery and materials researchers results without external software.

View product
HIOKI IM3523 / IM3533 LCR Meter

Electrical test & measurement

HIOKI IM3523 / IM3533 LCR Meter

The HIOKI IM3523 and IM3533 are LCR meters with ±0.05% rdg accuracy and a 2 ms measurement time for component testing. The IM3523 (DC, 40 Hz to 200 kHz) is designed for integration into production lines and automated test systems. The IM3533 (DC, 1 mHz to 200 kHz) adds transformer measurements such as turn ratio, mutual inductance and inductance difference, with temperature-compensated DCR, for winding and coil production, R&D and electrochemical applications.

View product

Need help with the right configuration?

Share your measurement requirements and site conditions. We can review the product configuration with you before preparing a quotation.

Request a quotation